JST Battery Removal Tool

Easily and safely disconnect JST-PH batteries with the SparkFun JST Battery Removal Tool, saving your fingers and preventing damage to wires or connectors.

The SparkFun JST battery removal tool is a tool to remove a standard 2-pin JST-PH connector (2mm pitch) from its housing! Use the JST battery removal tool to remove a LiPo battery's 2-pin JST-PH female connector. Save your fingertips from grabbing the connector when wiggling the connector out. Avoid accidentally pinching the wires when using needle nose pliers. Or save your wires from being cut when using a diagonal cutter. Simply slide the tool over the LiPo battery's JST female connector with one hand. With your other hand holding the male connector, pull the JST female connector away to disconnect the battery.

The JST battery removal tool is not intended to insert a JST female connector into the male connector. This tool will work for most board designs with the JST male connector populated on the edge of a board. Certain boards with the JST male connector port facing toward the inside of the board may have components that will cause an obstruction when using the tool. Connectors that are populated close to the JST connector may also be another obstruction when using the tool.

More information is available on the website of Sparkfun.