The SparkFun Serial Basic Breakout is an easy-to-use USB-to-Serial adapter based on the CH340G IC from WCH and takes advantage of the handy USB-C connector. It works with 5V and 3.3V systems and should auto install on most operating systems without the need for additional drivers. It’s a great lower-cost alternative to the extremely popular FTDI Basic.
There is a jumper on the rear of the board that controls the output voltage on the VCC pin. By default, the board outputs 3.3V and has 3.3V signals. Changing this jumper to 5V will cause the board to output 5V on the VCC pin with 5V signals.
More information ia available on the website of Sparkfun.
Bundles
- X1Serial Basic Breakout - CH340G and USB-C+X17" Jumper wires, 30 stuks7" Jumper wires, 30 stuks
Deze draden zijn geschikt voor een breadboard. De lengte is 7" (18 cm) en het is een set van 30 stuks in verschillende kleuren.
+X1Break Away Headers - StraightBreak Away Headers - StraightDeze 40 pins header connector kan op iedere lengte afgebroken worden. De afstand tussen de pins is 0.1" (2,54 mm). De connector kan op breakout boards gesoldeerd worden voor gebruik op een breadboard, voor gebruik met jumpers of voor gebruik met female jumper wires.
De specificatie vindt u op de website van Sparkfun.
+X1Breadboard - Self-Adhesive (White)Breadboard - Self-Adhesive (White)Dit breadboard heeft een zelfklevende achterkant en totaal 400 aansluitpunten.
De specificaties vindt u op de website van Sparkfun.Excl. BTW:€ 22,15 € 14,76
Incl. BTW:€ 26,81 € 19,42
50.03% discount on accessories
Experimenter basic (+headers)